• Hello there guest and Welcome to Fox Body Mustangs forum, This forum is intended to be used by enthusiasts of the Fox body Ford Mustangs (1979-1993)!
    To gain full access you must Register. Registration is free and it takes only a few moments to complete.
    Already a member? Login here then!

foxbody

  1. N

    91 GT Dies anytime after first start

    Issue where 91 GT has to be jumpstarted to run, only thing that’s been replaced is stater solenoid so I’m thinking it has something to do with that. When’s car running it’s 100% fine turn off go to get back in and it needs jumped. Good voltage on battery and when cars running alternator seems...
  2. FoxF350

    93 lx 5.0 conversion

    Hi everyone, I’m from Florida with a 93 fox. It used to be a 4 cylinder teal car, I bought it as a black 5.0. I love the car, but so far it hasn’t loved me haha. I’ve had my fair share of issues, so I’m hoping to get a little more involved in this community. I also really need to take some...
  3. N

    ECM issue still?

    Have a 91 GT. GT40 build on a 302. Ran fine a couple weeks ago. Went to start it and battery was dead. New battery and it then had the endless priming of the fuel pump. Looked up a bunch of forums and everyone said ecm was issue and to replace capacitors. Replaced all 3. Which were all bad and...
  4. foxbodydream

    Chocolate Fox Car Show 2022 (All Foxbody) in Hershey, PA

    We filmed a YT video of the cars rolling into the event and got some close-ups of some of the nicest cars at the show, including a Saleen. If you want to check it out you can here: Chocolate Fox Car Show 2022
  5. MuricMustang

    Can You Help With Installing Aftermarket Steering Wheel 87 Mustang?

    Hello guys! I bought an aftermarket Volante steering wheel from CJ Pony Parts and they sent me the hub adapter and everything I need it says for my mustang and here it is https://www.cjponyparts.com/cj-classics-steering-installation-hub-6-bolt-aluminum-mustang-1984-2004/p/STWA86-V/ but it won't...
  6. J

    Subframe connectors

    So I have a 91, and I was looking to get some subframe connectors. I noticed that for the same price of 65” bare metal connectors I can get 43” powder coated connectors with powder coated rear control arms. Should I spent the extra to get the full length or would the shorter ones be fine?
  7. J

    1986 Mustang GT 5.0 (5 speed, 37k original miles)

    1986 Ford Mustang GT 5.0 Little to no rust on the body. Garage kept its whole life, was never a daily driver. CLEAN Illinois title. Original unmodded 5.0 V8 with 37k miles, runs strong. Original 5 speed trans w/ stage 2 clutch installed. Just had front suspension work done to stiffen it up...
    • jczajkowski
    • Thread
    • 1986 5 speed 5.0 ford foxbody manual mustang original red sale
    • Replies: 1
    • Forum: Classifieds
  8. R

    '88 LX Project

    Just picked up a 1988 LX and it has a 302 from a 94 GT in it along with a built c4 trans but none of it is really wired. What I'd like some input on is what needs to be done electrically to get to the point of having it running and driving. Any input would be greatly appreciated!
  9. Frankz

    Project foxbody need help

    i have a 1993 mustang lx 5.0 302. Has a cold air intake, full exhaust, gears, suspension, short shifter. Everything else is stock. I’m on a tight budget should I engine swap for a blueprint 347 or put a turbo in it with heads intake and cam. Which one should I do
  10. P

    Forsale $$125 86-93 Brand New BBK Shorty Unequal Length Headers

    Have a never used set of BBK polished ceramic unequal length shorty headers to sell. These are 50 state legal with a CARB exempt number engraved on an emblem. Cost 300$ anywhere online. I dont have gaskets or hardware though. Only asking 125+ shipping to continental US and no rural areas...
Top